no transformer is required for speaker connection. The front panel includes a Power indicator LED, a Volume control and two Clip LEDs which indicate circuitry overload. The output circuitry is protected from momentary shorting and excessive load by a specially designed protective circuit.  (less)

consuming assembly. They simply replace half of a 2 x 2 tile or one quarter of a 2 x 4 tile and are supported by the T-bar grid. Ready-to-install system includes a speakertransformer assembly mounted to a 1 x 2 sub-plate with fine-perforated grille, built-in Tbar across support, and pre-mounted point8 .8 cu.ft. volume backbox with acoustic lining for extended low frequency performance. Built-in T-bar cross support is a Lowell exclusive that saves installation time by eliminating the need to field cut or mount an extra ceiling grid frame member. Each assembly mounts as tile ceilings. The grille is precision-formed from perforated steel with an integral two-foot T-bar to support neighboring tile. Material and labor saving des...  (less)

into Lowells 10D volume acoustic backbox Model IX610. The CN6 and CN8 Series speaker assemblies are special in that the factory installed driver is attached directly to an inner flange of the backbox. This removes the traditional weight bearing requirements limitations from the grille, allowing a heavier, higher performance driver to be used with a visually. System driver Model 6A40 is part of Lowells A-Series of speakers.It achieves excellent music and voice reproduction over a large coverage area. The 6.5 driver features a 10oz. magnet coupled with a 1-inch copper voice coil driving a polypropylene cone with half-roll rubber surround for long cone travel and good edge damping. T...  (less)

The unit also furnished with a line voltage selector on the rear panel to allow monitoring of 25, 50, 70 and 100-volt line outputs.  (less)

terminals for Mics 5 & 6 and telephone input. Output taps include: 8 ohm, 25 volt, 25 volt center tap, 70 volt, and 100 volt, as well as direct 4 ohm, tape out, preamp out, power amp in, and booster out. Other features include: * Dual Equalizer for acoustic shaping or feedback control * Aphex Aural Exciter circuit for added presence and intelligibility * Phantom power * Contour control * Precedence circuitry * Remote volume control * Auto mute on telephone page * Low cut filter * Frequency response: 20-20,000 Hz +0/-1dB (direct), 65-20,000 Hz +0/-2 dB (transformer) * Distortion: 0.5% (max), 0.3% (typical) * Dimensions: 3-1/2" H x 16-1/2" W x 12" D.  (less)

loaded speaker terminals are provided with 4, 8, and 16 ohm outputs, plus a 70 volt output line. Includes master volume, 3 band frequency equalizer, and a priority terminal that when connected to a switch gives exclusive priority to the MIC 1 input. Frequency response: 70-20,000 Hz. Dimensions: 3" H x 11-7/16" W x 7-5/8" D. Net weight: 9-3/4 lbs.  (less)

six selectable taps of 0.9W, 1.8W, 3.7W, 7.5W, 15W, 30W, plus a 16 ohm position. The 16 ohm position is a transformer bypass that allows the user to step around the transformer and use the Chameleon Micro Spot as a 100 watt speaker. The bracket allows the Chameleon Micro Spot to be mounted to any wall, ceiling, table, or other surface. The Chameleon Micro Spot features the proprietary Galaxy Audio NEOLITE neodymium 5" driver with a ferrofluid cooled voice coil that reduces both power compression and distortion. Specifications: • Power handling capacity: 100W RMS • Frequency response: 300-15,000 Hz • Sensitivity: 92 dB (1W/1m, 1 kHz octave band) • Maximum SPL: 117 dB (100 watts @ 0.5 m) • Volume c...  (less)

six selectable taps of 0.9W, 1.8W, 3.7W, 7.5W, 15W, 30W, plus a 16 ohm position. The 16 ohm position is a transformer bypass that allows the user to step around the transformer and use the Chameleon Micro Spot as a 100 watt speaker. The bracket allows the Chameleon Micro Spot to be mounted to any wall, ceiling, table, or other surface. The Chameleon Micro Spot features the proprietary Galaxy Audio NEOLITE neodymium 5" driver with a ferrofluid cooled voice coil that reduces both power compression and distortion. Specifications: • Power handling capacity: 100W RMS • Frequency response: 300-15,000 Hz • Sensitivity: 92 dB (1W/1m, 1 kHz octave band) • Maximum SPL: 117 dB (100 watts @ 0.5 m) • Volume c...  (less)

jacks with individual level controls, pair of RCA jacks for phono or AUX/CD with level control. Spring loaded speaker terminals are provided for 4, 8, and 16 ohm loads, plus a 70 volt output line. Include master volume, tone control, and spring loaded speaker terminals. Frequency response: 150-20,000 Hz. Dimensions: 3" H x 11-1/2" W x 7-3/4" D. Net weight: 7-3/4 lbs.  (less)

volt transformer with six selectable taps of 0.9W, 1.8W, 3.7W, 7.5W, 15W, 30W, plus a 16 ohm position. The 16 ohm position is a transformer bypass that allows the user to step around the transformer and use the Chameleon Micro Spot as a 100 watt speaker. The bracket allows the Chameleon Micro Spot to be mounted to any wall, ceiling, table, or other surface. The Chameleon Micro Spot features the proprietary Galaxy Audio NEOLITE neodymium 5" driver with a ferrofluid cooled voice coil that reduces both power compression and distortion. Specifications: Power handling capacity: 100W RMS Frequency response: 300-15,000 Hz Sensitivity: 92 dB (1W/1m, 1 kHz octave band) Maximum SPL: 117 dB (100 watts @ 0.5 m) Volume control: 18 dB range; 7 positions at 3 dB each Dimensions: 7" H x 6" W x 5-1/8" D. Features: High impact ABS and styrene plastic enclosure materials Barrier strip input connections Now includes front-mounted volume control SA-1 spun aluminum stand adapter and mounting bracket included 70V and 16 ohm connections Get Your Galaxy Audio MSPMVCW Today!  (less)

of .9w, 1.9w, 3.8w, 7.5w, 15w, 30w, and a 16 ohm tap.  The 16 ohm tap is a transformer bypass that allows the user to step around the transformer and use the Chameleon Micro Spot as a 100 watt speaker.  Its integral volume control allows the user to easily have more control over the volume.  The bracket allows the Chameleon Micro Spot to be mounted to any wall, ceiling, table, or other surface.  The Chameleon Micro Spot features the proprietary Galaxy Audio NEOLITE neodymium 5" driver with a Ferrofluid cooled voice coil that reduces both power compression and distortion. Specifications: Frequency response: 300 Hz –15 kHz Power handling capacity: 100 Watts Sensitivity: (1 watt @ 1Meter) 92 dB (1 kHz octave band) Maximum SPL: (100 watts @ .5 meter): 117 dB Speaker complement: One NEOLITE Neodymium, ferro fluid cooled 5 -inch drivers .86 lbs (.39 kg) Nominal impedance: 16 ohms Input connection: Screw terminals Volume control: 18 dB range; 7 positions at 3 dB each Enclosure Materials: High impact ABS and Styrene plastic Color: Black or white case with cloth covered ABS grille Included: SA- 1 spun aluminum stand adaptor and mounting bracket included. Dimensions: 7" x 6: x 5.125" (178 x 152 x 130 mm) Volume control: 18 dB range; 7 positions at 3 dB each. Net weight: 3.68 lbs. (1.669 kg) (without bracket) Tap Selector: 6 screw taps plus a 16 ohm position; .9w, 1.9w, 3.8w, 7.5w, 15w, 30w, and 16 ohms Shipping weight: 5.62 lbs. (2.55 kg) Get Your Galaxy Audio MSPMVCB Today!  (less)